Use Correct Way To Install pe fitting Cover Image
11

Jan

Use Correct Way To Install pe fitting

  • days
  • Hours
  • Minutes
  • Seconds
Custom Thumbnail 

Drop Image Here OR Browse To Upload

Add answer
Create album
  • Feeling
  • Traveling to
  • Watching
  • Playing
  • Listening to
  • Happy
  • Loved
  • Sad
  • Very sad
  • Angry
  • Confused
  • Hot
  • Broken
  • expressionless
  • Cool
  • Funny
  • Tired
  • Lovely
  • Blessed
  • Shocked
  • Sleepy
  • Pretty
  • Bored
0%
Use Correct Way To Install pe fitting has not posted anything yet
Start date 01-11-20 - 11:00
End date 01-23-20 - 06:00
  • Description

    The flexible nature of polyethylene pipe allows it to be used in colder climates -- where it will not crack -- and in situations where rigid pipe would require multiple elbows to make complex turns. Unlike other plastic piping, poly pipe connections do not use glue to solvent weld pieces together. Instead, two specially designed pe fitting types seal poly connections using friction. Both types have specific installation instructions to ensure they hold connections together under pressure.

      Barbed Poly Fitting Installation

      1Cut the required length of tubing from a polyethylene pipe roll with a sharp-bladed utility knife. Make sure the cut is straight. Slide a hose clamp over the end of the pipe. The hose clamp size must match the size of the tubing.

      2Dip one end of a barbed poly fitting in a water-based lubricant. Hold the lubricated fitting in your dominant hand and the cut piece of tubing in your other hand.

      3Forcefully push the fitting into the end of the tubing as you twist the fitting back and forth.

      4Slide the hose clamp toward the fitting until the end closest to the fitting is 1/4 inch away from the end of the tubing. Turn the clamp screw clockwise with a 5/16-inch nut driver to lock the fitting in place.

      Compression Fitting Installation

      1Hold the center nut of a compression fitting with an adjustable wrench. Turn one of the two outer locking nuts counterclockwise with a second adjustable wrench. Turn the wrench until the outer locking nut is loose but do not take apart the fitting.

      2Slide an end of a piece of poly pipe into the loosened side of the compression fitting. Slide the pipe until you feel the pipe bottom-out inside the fitting. Turn the locking screw clockwise with the adjustable wrench until it is tight. A tight locknut does not allow the pipe to move in the fitting body.

      3Loosen the second locknut with the adjustable wrench. Slide the loose end of a second piece of pipe into the open side of the fitting. Turn the locknut clockwise to lock the second piece of tubing in the fitting body.

      Things You Will Need:

      Polyethylene pipe roll

      Utility knife

      Hose clamp

      Barbed poly fitting

      Water-based lubricant

      Nut driver, 5/16-inch

      Compression fitting

      2 adjustable wrenches

      Tip

      Heat the end of a poly pipe with a hair dryer if the barbed fitting is difficult to insert in the tubing.